Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-13-2002, 09:24 AM
|
#5 |
|
Registered Member
Join Date: Feb 2001
Location: Brooklyn originally, but Grand Rapids now
Posts: 309
|
for street use do you think i should stick withe the 1.90 valve, and should i go with alum. or iron. it seems to me that if im doing street only then it would be more conservitave to stick with iron, then again its not too conservative to be 20 with a mustang like mine......so what do you think?
__________________
Grand Valley State University Senior Accounting and Finance Major 1985 Mustang GT 19,000 ORIGINAL miles, E-303 cam, edelbrock performer RPM intake, holley 600 cfm carb, MAC headers, windage tray, 8.8 rear end with 4.10 gears, 4"cowl hood, 5lug conversion, 04 Mach1 wheels. http://www.mustangworks.com/cgi-bin/moi-display.cgi?1501 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| Head to head | Oldschoolpony | Windsor Power | 3 | 07-01-2002 04:12 PM |
| Broke bolt in new head (Kinda Long) | 1988GTCONERTIBLE | Windsor Power | 6 | 05-12-2002 02:00 PM |
| blew a head gasket on a '93 sable | st5150 | Small Ponies | 0 | 03-21-2000 09:43 PM |