Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-05-2001, 10:00 PM
|
#2 |
|
Registered Member
Join Date: Jan 2001
Location: ny
Posts: 197
|
the setup seems good assuming youre using good rods. the pistons are ok but trw pistons are slugs. theyre big and heavy. also, for the amount of power your looking for that tci aod is not likely to hold up for long. you would have been better off with a good c-4 in both the strength and power dept. and you would have saved money. as for a cam your best bet is to talk it over with the cam company of your choice.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1968 engine numbers, 289 or 302? | andybud | Classic Mustangs | 5 | 09-11-2003 12:14 PM |
| Opinions on engine set-up | 90lxracer | Windsor Power | 8 | 10-11-2002 08:21 PM |
| Comments on this Nitrous System | 93boss | Windsor Power | 3 | 03-20-2002 05:19 PM |
| Need opinions. Intro to the Sci Fi story I'm writing. LONG | Mercury | Blue Oval Lounge | 11 | 06-25-2001 08:35 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |