Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-26-2002, 10:57 AM
|
#7 |
|
Registered Member
Join Date: Oct 1999
Location: new windsor,ny
Posts: 75
|
make sure you take your time cleaning all your gasket surfaces so that you dont have to put it all back together more than once, and all should be well otherwise. when you go to put the balancer back on, make sure you use some white grease on it and it should slide on far enough to where you can use the balancer bolt and washer to re-install it, instead of getting a balancer installation tool.Make sure you torque it to specs too, should be somewhere in area of 70ft/lbs or so, and then check it again in a few days just to be on the safe side.
hey drudis.... thanks for your help with my project. it runs fine now and had no problems putting it all back together. but wouldnt you know it, when i went to leave work this morning, i found that my air pump locked up on me and wont budge...lol its always something talk later jerry
__________________
650 Holley DP,Flowmaster American Thunders,H-pipe,American Racing rims, short throw shifter, T-5 , Zoom clutch, Dynagear timing,Kenwood stereo,FMS sparkplug wires,GTS smoked light covers |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with harmonic bal install | jsalerni | Classic Mustangs | 1 | 02-25-2004 01:00 PM |
| Harmonic Damper | TTOP50 | Windsor Power | 3 | 01-21-2004 09:58 PM |
| Harmonic Balancer | 95_MUSTANG_95 | Windsor Power | 3 | 05-28-2003 09:48 AM |
| Harmonic balancer trouble | 90LxDroptop | Windsor Power | 4 | 12-03-2002 10:49 AM |
| Harmonic Dampers | IMPULSERACING | Windsor Power | 1 | 02-19-2001 07:55 AM |