

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#10 |
Registered Member
Join Date: Feb 2002
Location: Alberta Canada
Posts: 17
|
![]() I i wanted to say before is that it works and while it is weaker it will hold up to some abuse. I have had mine in for a while and havent come across anything yet. But if something goes wrong it wont happen over time anyways. As for torque handling i know the 4 cyl one only handles 240lb ft but the earlier v8 t5's only held 265. 89' was when they started making the ones which could handle 300lb ft. But if your on a budget, like me, you can make due with the 4cyl tranny, but dont expect it to last forever. But if you can go for a new tranny, im looking into a 6spd for mine over the summer.
__________________
1982 Red GT Performer RPM Heads, Performer RPM air gap intake, Performer 600cfm carb holley blue pump, DF clutch, 8.8"w/3.08 posi, and many more. |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rocker adjustment | zach0 | Classic Mustangs | 3 | 04-24-2004 12:28 PM |
8 cylinder into a 6 cylinder engine bay....? | EclipseGST303 | Windsor Power | 8 | 10-04-2002 01:57 PM |
8 cylinder into a 6 cylinder engine bay....? | EclipseGST303 | Modular Madness | 1 | 10-02-2002 07:31 PM |
Master Cylinder | Sneaky | Windsor Power | 3 | 03-06-2002 12:13 PM |
4 cylinder to 5.0 conversion | saleen243 | Windsor Power | 5 | 02-26-2002 09:45 PM |