Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-04-2002, 08:50 AM
|
#5 |
|
Registered Member
Join Date: Aug 2001
Location: Georgia
Posts: 84
|
If you have one of those oil priming tools that connects to a dril and sticks where the dist does you could check to see if the oil pump is locked up. If you dont I would call the local parts store tho see if you could rent one from them. Be sure to have someone turn the motor by hand while you look down the dist. hole and amke sure the cam teeth are OK.
__________________
73 coupe, 351W, GT-40 heads, edlebrock 750, offenhauser intake, .488 lift cam, 2.5 exhaust, 2 chamber flowmasters, blah, blah, blah... |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| to carb, or not to carb...this is my question. | black86notch | Windsor Power | 4 | 08-06-2002 08:24 PM |
| Carb Woahs | RoadWarrior | Classic Mustangs | 4 | 07-27-2002 11:06 AM |
| '65 Carb Question | Wendell Allen | Classic Mustangs | 3 | 07-13-2002 04:54 AM |
| efi to carb. /? | WADS56 | Windsor Power | 0 | 09-26-2001 12:45 AM |
| new carb..but how much cfm?? | 69PonyRider | Classic Mustangs | 4 | 09-13-2001 07:59 AM |