Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-07-2002, 04:32 PM
|
#8 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
ok since i haven't messed with pipe threads in a little while, i kinda got myself and possibly you confused
 When I was in my senior year of highschool (2000) I was accepted in a training program job at Eli Lilly and Co as a machinist. When I was turning pipe threads on the lathe I was tought to get it close enough to where the fitting would go on 2.5 turns BY HAND, and then tighten it the rest of the way. sorry for the confusion, i wasnt thinking right and therefore told you the wrong information. So it should get hand tight a little over 2 turns, then you can wrench it. sorry again
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trouble shooting trouble codes? | HiFlow5 0 | Windsor Power | 2 | 04-12-2002 06:29 AM |
| putting motor back in | Patrick Boetticher | Windsor Power | 6 | 03-05-2002 02:11 PM |
| header trouble | musclestang86 | Windsor Power | 0 | 08-13-2001 10:22 PM |
| Short Throw Trouble Anyone? | CobraFire98 | Modular Madness | 0 | 07-01-2001 10:23 AM |
| Putting in 2031 Saturday | withamc | Windsor Power | 7 | 02-17-2001 11:00 PM |