

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: Dec 2000
Location: Waterloo, ON, Canada
Posts: 214
|
![]() ok, thanks guys, I'm going to run some cleaner through it, and try the octane boost, then try dropping it down to 8 degrees..
the cap, rotor, wires, plugs, etc, are all new, BUT, what should fuel pressure be set at??? Would the new 190 lph increase fuel pressure? (i read that a new pump will only bring it back to stock pressure, as the old pump was getting weak and pressure could have been lower) thanks !! |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
24 degree's timing?? | Saltmaker | Windsor Power | 7 | 10-13-2001 10:49 AM |
Im running 21* of timing! | 91evilstang | Windsor Power | 4 | 08-27-2001 02:11 PM |
Stock timing, 93 octane and I still get detonation????HELP! | StangDan | Windsor Power | 8 | 06-30-2001 02:45 PM |
Dyno results inside with timing adjuster installed | Mustang92 | Modular Madness | 7 | 02-20-2001 09:24 PM |
LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |