Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-12-2002, 08:55 AM
|
#8 |
|
Registered Member
Join Date: Nov 2001
Location: germantown MD
Posts: 283
|
I will take another look. The tab fits fine. It is the outer piece of the eccentric that rubs. Without the outer piece the eccentric fits fine. I don't plan on spinning it very high and the cam gear only spins half of what the crank does anyways. I think I will install it with just the one piece. After all I can always take it out and try grinding the cam gear if it causes too much heat. Thanks for all the help.
__________________
85 GT 4bbl roller cam 2 ch. Flowmasters, O/R H-pipe Performer intake and carb milodon water pump, FMS 9mm wires, aluminum driveshaft, king cobra clutch |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 94 GT fuel pump relay | phantom74 | Windsor Power | 0 | 02-01-2004 07:14 PM |
| 255lph fuel pump install | white91gt | Power Adders | 7 | 08-06-2003 11:23 AM |
| Fuel pump relay questions | Big Bopper | Windsor Power | 1 | 11-10-2002 10:20 PM |
| Fuel pump blues | lil oregon guy | Windsor Power | 7 | 10-22-2001 12:35 PM |
| Fuel Pump Replacement | KobraLX | Windsor Power | 1 | 07-31-2001 12:44 PM |