Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-12-2002, 09:13 PM
|
#8 |
|
Registered Member
Join Date: Jun 2001
Location: Topeka
Posts: 15
|
I only put two in mine. The washers I found were extra thick. I think you should be fine. Do you have caster camber plates? I used an impact to tighten the ball joint nut and it's pretty tight. As tight as I felt comfortable making it. I have stripped those things out before so I didn't want to go that far. It almost takes two people to get those holes lined up. I couldn't imagine doing it without coilovers. How are you doing the rear?
__________________
89 Notchback Many parts and pieces 93 Lightning few new parts... Check site for mustang videos www.streetscene.org |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|