Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-14-2002, 10:42 PM
|
#1 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
I'd say shoot for 150psi, but as previously stated, it really does depend on several things. Most important is that the results are uniform. The highest reading shouldn't be more than 20% higher than the lowest reading. Also as mentioned, make sure the engine is warm, all plugs are removed for the entire test, the throttle is blocked at WOT, and the coil is disabled.
Take care, -Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| increasing compression ratio | 84LX89GT | Windsor Power | 6 | 11-14-2003 10:40 AM |
| #1 @ TDC on compression stroke? | 302 LX Eric | Windsor Power | 1 | 09-23-2003 04:19 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Need help!...no compression in 6 and 7!! | bobtodd | Windsor Power | 6 | 09-13-2002 03:09 PM |
| high or low compression engines | Mustangboy89 | Windsor Power | 6 | 01-26-2001 03:04 PM |