Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-19-2002, 05:52 PM
|
#5 |
|
Registered Member
Join Date: Jan 2000
Location: greenvile, NC
Posts: 161
|
The 93 cobra caliper are the same as the 87-93 lx/gt.
The 94-up cobras use PBR 2 piston aluminum calipers with 13" rotors. You have to use the spindles, rotors, brake lines, master cylinder, and hub assembly from the cobra to fit those calipers on your car. I have pretty much the best 4lug "Ford" setup out there.. its ok...nothing special. 73mm Steel piston calipers Braided brake lines Stainless caliper sleeves Thunderbird rear disks Baer Proportioning valve SVO master cylinder Check out this site for more details...http://svo73mm.cjb.net/ Quit making me drool Darius... 
__________________
89' Notch Stroked Poked & BLOWN low 11's and it goes around corners too Parts for Sale!! http://www.lowkey.stangnet.com/catalog.html |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cobra calipers | scurr3165 | Modular Madness | 0 | 03-13-2002 03:35 PM |
| SVO Calipers | cyberstang5.0 | Modular Madness | 0 | 11-02-2001 01:50 PM |
| Installed Lincoln calipers | poopstang | Windsor Power | 6 | 07-01-2001 07:34 PM |
| Front Calipers | RMARIANI | Windsor Power | 4 | 06-22-2001 06:36 PM |
| manual break master cylinder for large calipers | n2ojunkie | Windsor Power | 2 | 03-16-2001 01:33 AM |