Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-20-2002, 01:07 AM
|
#1 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
The subframes should be designed to fit over the frame sections and connect them. If you look underneath your car, there will be frames that extend below the normal underbody behind the front wheel, and in front of the rear wheel. These are connected via the subframes.
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| weld an intake??? | whitepony | Windsor Power | 12 | 04-17-2004 03:10 PM |
| What makes a weld job a quality weld job? | BlackFireN2O | Windsor Power | 19 | 09-02-2002 11:30 PM |
| Welding in subframes and removing front sway bar . What should I run?? | Dark_5.0 | Windsor Power | 4 | 10-27-2001 03:06 AM |
| Round tube subframes for 87-93? | Mad Horse | Windsor Power | 7 | 04-02-2001 09:00 PM |
| Need some input regarding Weld wheels | Ares | Modular Madness | 3 | 03-05-2001 08:59 PM |