Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-22-2002, 08:47 PM
|
#1 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
Personally I wonder if it's a 1982 HO that is being talked about, or a roller HO. What hasn't been mentioned here is that the roller HO cam will require roller valvetrain, and if I'm not mistaken, the camshaft itself won't work with your block. (Roller conversions are made for a different camshaft diameter, aren't they?)
The 1982HO cam is as follows: .416/.445 198*/208*@.500 and 260*/274* overall. I think the standard cam back then was the same as the 255 .380/.380 244*/244* overall. The 1979 5.0's used .381/.397 244*/256* overall |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Specs on my Camshaft | Kisner | Classic Mustangs | 2 | 08-01-2004 12:55 PM |
| ported gt40's and stock camshaft | chiaronate | Windsor Power | 11 | 04-14-2004 05:15 PM |
| Camshaft Question | SmokinStangGT | Windsor Power | 7 | 10-20-2003 12:40 AM |
| camshaft gains w/new stuff | 84LX89GT | Windsor Power | 5 | 06-30-2003 09:18 AM |
| camshaft selection | chiaronate | Windsor Power | 2 | 06-09-2003 02:17 AM |