Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-23-2002, 08:35 AM
|
#1 |
|
Registered Member
Join Date: Dec 1998
Location: Richmond, Virginia
Posts: 449
|
in-car head swap question?
What should the block surface look like before I put the heads on...I have scraped it with a razor blade and cleaned it with solvent - it is clean, but still discolored.
Is this okay, or should I clean it till it looks like machined metal? thanks Also - do the Fel-Pro 1011-1 gaskets need retorqueing after running? Matt
__________________
1982 Mustang GT |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head swap question | shoyoas | Modular Madness | 2 | 05-02-2003 07:48 AM |
| Head Swap finally Done | Badass_yellowGT | Modular Madness | 3 | 11-14-2002 02:34 AM |
| Head swap question | Badass_yellowGT | Modular Madness | 11 | 11-04-2002 11:19 PM |
| Thinking of 99 head swap? BEWARE... | 97ScottieGT | Modular Madness | 7 | 03-14-2002 01:43 PM |
| head bolt question... | avbcon12 | Windsor Power | 4 | 02-23-2002 09:13 AM |