Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-23-2002, 08:46 AM
|
#2 |
|
Registered Member
Join Date: Feb 2002
Location: Warren, Mi.
Posts: 50
|
I usually stuff the bores with rags or paper towels and use scotch brite pads to scuff the surface. Then make sure you vaccum any debris, it work's for me. I don't think you will need to retorque the head gaskets, I think thats for copper gaskets but I could be wrong, hope this helps.
__________________
91 GT Convertable, 306, TFS TW heads, B41 cam, Holley Systemax, S-Trim, Bassani LT's, and Flo's |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head swap question | shoyoas | Modular Madness | 2 | 05-02-2003 07:48 AM |
| Head Swap finally Done | Badass_yellowGT | Modular Madness | 3 | 11-14-2002 02:34 AM |
| Head swap question | Badass_yellowGT | Modular Madness | 11 | 11-04-2002 11:19 PM |
| Thinking of 99 head swap? BEWARE... | 97ScottieGT | Modular Madness | 7 | 03-14-2002 01:43 PM |
| head bolt question... | avbcon12 | Windsor Power | 4 | 02-23-2002 09:13 AM |