Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-18-2001, 06:29 PM
|
#2 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
I've never heard of that technique, as far as up and down, if there is basically any play, I would think it's shot. I can't figure out how an in and out play would be the bearings?
The T-5 went from a needle bearing (much like the setup in a U-joint) to a tapered roller bearing for more durability. The input shaft, first gear, and the 3rd gear syncros are usually the weak points on the T-5. Did you sell your other T-5? You may be able to slap that in there as a quick fix. Sorry you're having so many problems with the beastie.  [This message has been edited by Unit 5302 (edited 04-18-2001).] |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dist. gear......cast or steel? | dwatson | Windsor Power | 6 | 04-11-2004 11:32 PM |
| Distributor gear.... is it steel? | DRASTiK | Windsor Power | 5 | 01-09-2002 12:37 AM |
| Rapid distributor gear wear on roller cam 351 | fxbill | Windsor Power | 5 | 01-08-2002 02:56 PM |
| new gear ratios | faststang90 | Windsor Power | 2 | 12-27-2001 03:29 AM |
| GREAT NEWS...HEATER CORE TOOK A **** | vande97 | Windsor Power | 8 | 10-03-2001 11:00 PM |