Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-26-2002, 09:38 PM
|
#1 |
|
Registered Member
Join Date: Oct 2001
Location: Madelia,MN USA
Posts: 58
|
Quick question
I have a quick question that kinda fits in here. I have a 93 Cobra computer in my cobra and has a ton more power than my 90GT if I have a custom chip burned will my computer be better "not remove so much timing or stay in close loop" or do I need to swap my Cobra computer for and earlier model??
__________________
331 stroker, JE 8.5:1 pistons, H-beam rods, steel crank, main cap, msd with 3step, BBK ceramic long tubes,TKO, 4.30's, motorsport Z303, Victor Jr aluminum heads, crane gold 1.6, southside lift bars, 90/10 front, 50/50 rear, centerforce dual friction clutch, Vortech S-trim soon. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Computer chip and ET's | DaTank | Windsor Power | 14 | 04-07-2003 08:53 PM |
| Which wiring harness and computer do I have to have? | EazyE-CPT | Windsor Power | 0 | 07-21-2002 11:33 PM |
| Help with C&L 76MM & A9L computer install | venumus93 | Windsor Power | 19 | 05-16-2002 07:58 PM |
| Computer Issues, Check Engine | 98SteedaGT | Modular Madness | 1 | 04-27-2002 05:39 PM |
| AAAARGH! Steeda timing adjuster causing computer problems!!! | bark3rd | Modular Madness | 1 | 06-04-2001 08:15 PM |