Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-31-2002, 10:31 AM
|
#4 |
|
Registered Member
Join Date: Jan 2002
Location: Va
Posts: 1,122
|
The best heads on the market for street/strip is DART. These heads have been proven time and time again. And about the debate whether or not Aluminum Vs. Iron which makes more power?? Well I've been and built plenty of competition racing engines and believe it or not, Iron makes more power simply because aluminum expands and anytime it expands it loses hp. So if your really into saving weight, then go aluminum, but if you want hp go Iron. Plus with iron you don't have to worry about warping your heads if the motor overheats....I've had that happen plenty of times!!! Hope this helps.
Eric
__________________
68 Camaro Gene Fulton 632ci Two stages of Jug 8.41 164mph Rockingham 1-26-03 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Heads. Any Tips | 66StangGuy | Classic Mustangs | 5 | 09-15-2003 08:20 PM |
| Edel. non-smog to AFR smog legal heads? What do you guys think? | Simi Stang | Windsor Power | 10 | 06-19-2003 11:14 PM |
| Cylinder heads for blown 331 | Dave_mustang_50 | Windsor Power | 7 | 06-18-2003 03:45 PM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |
| E7 cylinder heads | 89LXNB | Windsor Power | 2 | 01-02-2001 11:41 PM |