Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-31-2002, 01:35 PM
|
#8 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
GT40P. Get new headers, and the heads fully assembled for less than $700. Home port them.
You could do well with a set of GT40 Irons that have been milled and ported as well. Pretty cheap, no header change necessary. The Dart Windsor Jr's are good too, although I'm pretty unimpressed with their flow curve. You have no reason to spend an additional $300-$500 on aluminum heads, unless you really want to drop the weight. Without a cam the TFS or AFR heads aren't going to do anything more than the irons suggested. Even with a aluminum head and cam, you're only gonna pick up another 30hp over what irons will give you right now. You simply don't need 250cfm flow. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Heads. Any Tips | 66StangGuy | Classic Mustangs | 5 | 09-15-2003 08:20 PM |
| Edel. non-smog to AFR smog legal heads? What do you guys think? | Simi Stang | Windsor Power | 10 | 06-19-2003 11:14 PM |
| Cylinder heads for blown 331 | Dave_mustang_50 | Windsor Power | 7 | 06-18-2003 03:45 PM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |
| E7 cylinder heads | 89LXNB | Windsor Power | 2 | 01-02-2001 11:41 PM |