Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-31-2002, 09:54 PM
|
#5 |
|
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
Opentrack guys started to move away from these.
Once upon a time, pads neede "degassing". The pads heated and would (lets just call it) "boil". The slots (or holes) allowed the gasses to bubble into the slot areas. Also it was a placee to clean the pads as they swiped by, like a windshield wiper... Most of the guys found many cracked (under SEVERE use). So noone seems to get these anymore IMOHO. At least guys I run with. [thats my story and I'm sticking to it] For a 4-lug 11" rotor, sure go ahead. You'll never get the pads (rotors) hot enough to make them glow red. Pads will fade to zero way before that (trust me, been there). I can get the 13" vented rotors hot enough to discolor them!  
__________________
Darius Rudis, Moderator Corner Carvers Delight 1989 Mustang LX - Open Track Car http://www.dariusrudis.com |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cross Drilled Rotors - Who uses them? | 2FastLX | Windsor Power | 6 | 09-29-2001 12:05 AM |
| Brake Rotors | 93GTDIN | Windsor Power | 6 | 09-06-2001 08:55 AM |
| Update on my scraping rotors | RMARIANI | Windsor Power | 0 | 09-05-2001 09:28 AM |
| 5 lug 11" dia rotors for fox body | MiracleMax | Windsor Power | 7 | 06-04-2001 11:34 PM |
| Drilled front rotors | Danielz9 | Corner Carvers Delight | 3 | 06-14-2000 01:00 AM |