Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-02-2002, 07:50 PM
|
#13 |
|
Registered Member
Join Date: Nov 2001
Location: SanAntonio, Tx
Posts: 734
|
No doubt, you guys rock!! about the nos, im probaly going to go with a TNT kit (texas nitrous technology) they are very reputable, and many stangs and f-bods use this kit, there rated hp kits actually rate at the rear wheels, so a 100 shot will give me somewhere around 100 at the wheels!!
 yes im preparing for the nos, FPR, 1.7 crane rockers, longtubes, and of course the heads, aluminum jr.s, this wont all happen at once, but a guy has to have a plan you know....thnx a whole lot!!going for low low 12's 
__________________
Police package 5spd 90 Lx, Stock original motor, 3.27grs, BM fan, fms 10.5 clutch, D&D quadrant, and adjuster, ADS chip, 180 stat, mac cai, mac h-pipe, mac subframe connectors, ASP crank pulley, ripper shifter, 26x10.5 M/T sport pros welds. 246 hp according to analyzer Race weight: 3,120 E.t-13.57 with 26x10.50's e.t. streets. 1.88 60' mph- 99.92 mph |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| Head to head | Oldschoolpony | Windsor Power | 3 | 07-01-2002 04:12 PM |
| Broke bolt in new head (Kinda Long) | 1988GTCONERTIBLE | Windsor Power | 6 | 05-12-2002 02:00 PM |
| blew a head gasket on a '93 sable | st5150 | Small Ponies | 0 | 03-21-2000 09:43 PM |