Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-04-2002, 08:37 PM
|
#2 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
Where the speedo cable enters the output shaft housing on the tranny, you should just have to pull one bolt holding it in, pull the cable out, remove the C clip retaining the gear on, slide the gear off, slide the new gear on, slip the C clip back on, slide the cable back into the output shaft housing, and put the bolt back in. (Don't over torque the little bolt)
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4.10 GEARS & EVERYTHING I need for the best possible install on 99 AUTOMATIC GT VERT? | jasonxst | Modular Madness | 2 | 08-05-2003 07:00 PM |
| New Gears, Install, and Questions | B2r3y | Windsor Power | 6 | 02-21-2003 05:00 PM |
| Ring and Pinion Install | Titan | Modular Madness | 21 | 08-15-2002 10:06 PM |
| Speed compensator vs. Speedo gear? | 5.0PiMpin | Windsor Power | 4 | 01-13-2002 10:01 AM |
| Speedo calibration with 4.10's.QUICK! | todd95GT | Windsor Power | 6 | 10-12-2001 11:40 AM |