Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-04-2002, 10:36 PM
|
#6 |
|
Registered Member
Join Date: Sep 1999
Location: Vancouver, WA USA
Posts: 439
|
Yes they are 2 1/16 with the chrome bezel. I went and found an old back section from a dicarded instrument cluster, and then hogged that out. Ounce that was cut, I replaced the one already there. It will take a bit of dremel work from the front with some trial fitting, but once done, they snug in really nice. I did a drawing for the center panel and had it made up from 1/8 inch thick alum. and than had a buddy at a machine shop make it up for me.
Ron |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rewiring instrument cluster lights | GhettoPop | Windsor Power | 2 | 05-24-2004 10:38 PM |
| instrument cluster lighting | GhettoPop | Windsor Power | 3 | 04-24-2004 08:45 PM |
| DTC Codes on instrument cluster | mreihl | Modular Madness | 0 | 02-23-2004 08:59 PM |
| Instrument cluster | 79Mustang | Windsor Power | 1 | 06-09-2002 11:54 PM |
| 1966 Mustang - Housing Instrument Cluster | wdonley | Classic Mustangs | 2 | 12-31-2000 02:17 PM |