Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-23-2001, 12:22 PM
|
#1 |
|
Registered Member
Join Date: Jan 2001
Location: Kansas
Posts: 59
|
Personally I love my pro 5.0 shifter. I broke my t-5 and am now putting in a tremec TKO and i ordered a pro 5.0 for the tremec without even using the shifter that came with it. If you power shift it, the bolt stops would be a big plus on any aftermarket shifter. Shifting into third is no problem either. Whatever shifter you decide to get, i would try to make sure it has bolt stops to prevent breaking the shift forks.
------------------ edelbrock 6032 heads,cobra intake,b303,4.10 gear,tremec tko,vortech s trim,polished cobra r's,dual friction clutch |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 87-93 Center console arm rest options ?? | Katmandu | Windsor Power | 1 | 09-27-2003 12:31 AM |
| AFtermarket or factory fender | 7up | Windsor Power | 13 | 08-19-2002 11:30 PM |
| took rest of the semester off | RAGE_5.0 | Blue Oval Lounge | 3 | 12-11-2001 09:12 PM |
| will steeda tri-ax handle fit on my hurst short throw shifter? | SHaFT7 | Windsor Power | 1 | 06-10-2001 03:10 PM |
| Aftermarket 4.6 Heads & Manifolds & Blocks...WHERE ARE THEY!! got any ideas? | Shawn | Modular Madness | 3 | 09-26-2000 02:07 PM |