Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-24-2001, 04:33 PM
|
#9 |
|
Registered Member
Join Date: Jul 2000
Location: Harlingen, TEXAS
Posts: 75
|
I would buy a Pro 5.0 again, I used to have the old Hurst shifter.
------------------ 92'LX Notchback, BBK Fenderwall Cold Air EDELBROCK Per. Intake, C&L 73mm MAM, 70mm TB,Windsor Jr iron Heads port & polished, f303 cam, 1.6 Crane roller rockers MSD 6A, FMS 9mm wires, Underdrive pulleys, JBA headers, flowtech X, 2 ch. flow, 3.73, Pro 5.0 Shifter HD FMS Radiator, Max Motorsport subs, Max Motorsport Lower Control Arms, ...KN 12.99@106mph 60ft 1.75 w/ET Drags |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 87-93 Center console arm rest options ?? | Katmandu | Windsor Power | 1 | 09-27-2003 12:31 AM |
| AFtermarket or factory fender | 7up | Windsor Power | 13 | 08-19-2002 11:30 PM |
| took rest of the semester off | RAGE_5.0 | Blue Oval Lounge | 3 | 12-11-2001 09:12 PM |
| will steeda tri-ax handle fit on my hurst short throw shifter? | SHaFT7 | Windsor Power | 1 | 06-10-2001 03:10 PM |
| Aftermarket 4.6 Heads & Manifolds & Blocks...WHERE ARE THEY!! got any ideas? | Shawn | Modular Madness | 3 | 09-26-2000 02:07 PM |