

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#9 |
Registered Member
Join Date: Dec 1999
Location: louisville KY 40229
Posts: 32
|
![]() remember the shorter your runners better top end power, longer better low end breathing. It does somewhat help your air charge temp. to reduce, due to less metal to metal contact with HEAT soaked Lower intake. personally I use a half inch port matched cobra intake with no clearence problems. I strongly advise port matching spacer to BOTH UPPER AND LOWER. Since they don't always line up when bolted together. There is an easy trick on saving gaskets w/ spacers. Buy some brush on RED LIQUID GASKET and glue your gaskets to the spacer and they will not move upon installation!! I have used the same gaskets several times/
|
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
phenolic spacer | srv1 | Windsor Power | 4 | 09-09-2002 12:46 PM |
Phenolic heat spacer? | Extremestang | Small Ponies | 0 | 02-22-2002 12:13 PM |
EGR bocked by phenolic spacer | red90lx | Windsor Power | 1 | 10-19-2001 03:22 PM |
1" Phenolic Spacer for GT-40 Intake (no EGR) - Where can I get one? | 2FastLX | Windsor Power | 7 | 06-07-2001 02:36 AM |
Is my 1" Phenolic spacer hurting me? and TB ? | Rick 91GT | Windsor Power | 8 | 01-05-2001 01:23 PM |