Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-09-2002, 11:55 AM
|
#1 |
|
Registered Member
Join Date: Aug 1999
Location: Fairfax, VA
Posts: 220
|
On my 92, the schrader valve (covered by what looks like a tire valve cap) on the fuel line is very near the back of the alternator. To install the Electrical fuel pressure gauge you will need to unscrew the cap, remove the schrader valve (pliers will do), then screw in the sender. If you bought the $79 Electric gauge, you will need to get a 1/16 male to 1/8 female brass adapter - if you bought the $180 Electric gauge I think the sender comes with that fitting.
If you have a mechanical gauge - I am not positive, but I think you screw it on over the schrader valve. Also, the STOCK fuel pressure regulator does not have a port for the gauge (some aftermarket adjustable fpr's do - but Kirban does not).
__________________
1992 LX 5.0 Convertible Red/Blk Gears, Exhaust, bolt-ons... R.H.C. #51 |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking to buy and I need Advice...Fuel Pressure Test Gage and Compression Test Gage | MTU 50 | Windsor Power | 3 | 10-18-2002 05:34 PM |
| Fuel pressure won't drop after blower install! | exgmguy | Windsor Power | 5 | 05-30-2002 05:37 PM |
| Rising Fuel Pressure with Rising RPM? | StreetStang37 | Windsor Power | 1 | 05-21-2002 03:49 AM |
| Fuel Pressure Reg. install ?'s | chris91LX | Windsor Power | 2 | 11-24-2001 01:45 AM |
| Fuel pressure regulator install ?'s | chris91LX | Windsor Power | 1 | 11-14-2001 04:35 PM |