Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-11-2002, 10:30 PM
|
#1 |
|
Registered Member
Join Date: Feb 2002
Location: Diamond Bar
Posts: 258
|
yeah thats what had me wondering. it was 2 rotations of the driveshaft. thats what i meant when i said it rotated 2 times. but 2.00 gears dont exist on a stock mustang. would it make sense to put those in there if they did exist? I will try and check it again. i used a black marker to mark the driveshaft and the inside of the rim. also about the open or limited slip diff. i did have the other wheel lock. but if im thinking about this correctly. then if i didnt have it locked and it was turning then i would get a higher number of driveshaft rotations that would not match a gear ratior right? but insted mine are lower. im sorry i got mad but iv seen a lot of people get the wrong info and argue becuase someone didnt read the entire question.
__________________
66 mustang-292-Holley 4160-World Castings Windsor Sr.-Hooker super comp headers-MSD box & Coil.3.55 gears. B&M Z-Gate-Black leather racing seats with 4pt harnes. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Recommendations on a rear gear ratio | jim_howard_pdx | Windsor Power | 1 | 09-15-2002 12:10 AM |
| question on fuel system and rear gears and launching | vetteeatr | Windsor Power | 1 | 08-12-2001 05:28 PM |
| Gears, need help!!!! | Edgar Negron | Windsor Power | 3 | 05-27-2001 03:10 PM |
| Rear gears | dinomite | Corner Carvers Delight | 3 | 05-08-2001 05:25 PM |
| Recall 01S15 Rear Knuckle replacement | folthoff | Special Production | 0 | 05-02-2001 08:28 AM |