Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-15-2002, 12:03 AM
|
#4 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
My stock springs had about 100k on them when i put my 1.7's on originally. A few months later, I noticed that my valves were floating at about 5300 rpm and higher.
I put on a set of comp cams springs (about $70), which installed very easily, and the problem went right away. Also the car seemed to pull harder on higher RPM's as well.
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| val springs in stock 97 heads , quesion ? | southernstang97 | Modular Madness | 0 | 07-16-2002 11:52 AM |
| SystemaxII intake and Box stock RPM heads | NewAge 5.0 | Windsor Power | 4 | 01-18-2002 12:52 AM |
| Anybody use the GT-40P headers on stock heads? | Scappoose | Windsor Power | 3 | 01-15-2002 06:38 PM |
| 1.7 Roller Rockers, Hand Porting Exhaust Side Of Stock Heads... Good Idea??? | BowTie Eater 5 Liter | Windsor Power | 12 | 09-15-2001 02:00 PM |
| Best Heads For Stock Short Block | StreetStang37 | Windsor Power | 2 | 02-26-2001 11:10 AM |