Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-15-2002, 10:22 PM
|
#6 |
|
Registered Member
Join Date: Feb 2002
Location: Jacksonville, FL
Posts: 706
|
MAF setup...
My setup is a Moroso CAI to the factory bracket with a C+L 73mm. Then the stock rubber POS to the TB.
No probs. My idle surges a bit every now and then, but only at warmup and nothing too severe. It settles after warmup. I would love to see something written (technically) concerning the air flow into the MAF and it's implications. Tony at Hocus Pocus said he would like to try to orient the MAF at the 90* position for a comparison. I'll run it on a dyno for ya after I rotate it 90*. It can't hurt to try huh?
__________________
1988 GT Convertible 331 10:1 TW heads, GT-40 intake, MSD, TRW flattops, B Cam w/ 1.7's, MAC exhaust, 24's, 70 TB, 76 MAF, 3.73's, Pro 5.0, Koni's, Anderson PMS, Wideband 02, yatta, yatta... One week with new motor, two speeding tickets...joy |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C&L Clear sampling tube? | Falcons Talon | Windsor Power | 2 | 05-08-2003 08:14 AM |
| Heater water supply and return tube | Cody2552 | Windsor Power | 3 | 03-24-2003 11:34 PM |
| C&L Inlet tube | moc | Windsor Power | 14 | 04-12-2002 07:06 AM |
| New Inlet tube? | CaliJ1 | Modular Madness | 0 | 10-13-2001 07:19 PM |
| Oilpan, dipstick tube leak...help! | chris91LX | Windsor Power | 2 | 02-17-2001 01:26 AM |