Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-16-2002, 06:41 PM
|
#3 |
|
Registered Member
Join Date: Apr 2002
Location: Allentown, PA
Posts: 2
|
I have just found out there were three variations on the C-4 transmission, where the shaft gear has 8-9-10 teeth, or 7-8-9. In an case, I need to check the transmission, maybe I do not have the 'original' transmission. I did not pay attention to this during the rebuild, as it was functional.......
Tires are very close to the factory original in terms of the outside circumfrence. Back to the drawing board. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vacuum reading at idle? | exgmguy | Windsor Power | 20 | 09-27-2002 06:22 AM |
| What causes High Oil Pressure reading? | Whoapony94 | Windsor Power | 2 | 04-22-2002 08:55 PM |
| Help TPS still reading WOT, can't figure it out | gramsch | Windsor Power | 1 | 06-30-2001 07:01 AM |
| Why is my TPS reading WOT when throttle is closed? | gramsch | Windsor Power | 2 | 06-20-2001 04:38 PM |
| Informative reading for Fox-body owners | cleangreenmachine | Blue Oval Lounge | 8 | 01-10-2001 01:05 PM |