Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-17-2002, 11:31 PM
|
#2 |
|
Registered Member
Join Date: Apr 2001
Location: Bowling Green, KY
Posts: 95
|
Can't help you on the motor mount question, but it's quite ironic that my first pass was also a 16.20!! I was a tad retarded and left my windows down, and since I wear contact lenses, they started to come out of my eyes right past the 1/8 mile mark, so I freaked out and hit the brakes. That is the only time I have ever taken the first exit off the track!!
The next pass I made was a 15.1, which was a little bit redeeming. After some practice, I finally got down to 14.4 with some small mods along the way.
__________________
'90 Black Notch: TFS TW heads, Stage 1 Cam, Street Intake, FMS 1.6 rockers, Kirban AFPR, 24# injectors, C&L 76mm MAF, 70mm Accufab TB/EGR, Tremec 3550, SPEC Stage 2 & Billet Flywheel, Alum DS, 4.10's w/ 31 Spline Eaton, Full MAC exhaust, etc. 286.7 RWHP @ 5100rpm, 313.7 TQ w/stock MAF, Inj, TB, and no tune Race weight : 3090 # w/ driver New Best - 12.82@107.9 w/1.74 60' |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Should you run a solid lift cam with stock bottom | ciara | Windsor Power | 1 | 10-23-2003 11:12 AM |
| Solid Roller ? | STROKER BILLY | Windsor Power | 5 | 11-19-2002 12:04 AM |
| How to change from a roller to solid?? | Smokedawg | Windsor Power | 3 | 10-04-2001 11:03 AM |
| FRPP wires solid or spiral core??? | TEXSN95 | Windsor Power | 1 | 04-23-2001 10:23 AM |
| Solid Lifter Cam? | clearwaterms | Windsor Power | 1 | 01-08-2001 02:53 PM |