Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-18-2002, 12:11 PM
|
#22 |
|
Registered Member
Join Date: May 2001
Location: Oklahoma City OK USA
Posts: 236
|
The pilot and throwout bearings are two different things. the pilot bearing is pressed into the end of the crankshaft and the throwout bearing slides on the input shaft when you push the clutch to disengage the clutch. You WILL need to have both replaced. You SHOULD replace your quadrant and cable with new ones. the stock plastic quadrant and pawl have a nasty habbit of breaking and so does the stock cable. summit sells an aluminum quadrant and an adjustable cable together for under 100$. Replacing these parts will save you a headache in the long run. I dont know why the shop that does your clutch shouldnt get the bearings for you. They are avalible at most auto parts stores.
I wish you lived in Oklahoma i would do it for you for 100$ + parts.
__________________
90 GT 25th Anni. Did the AOD to T-5 swap, SPEC clutch, Steeda Tri-Ax shifter, BBK 2½ inch off-road H pipe, Flows, BBK 70mm TB/EGR, Ford Racing aluminim driveshaft, 3.55's, welded subframes, Ram Air, 3 core radiator, NOS dry kit 75 shot, and a K&N filter. 12.9 @ 108 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clutch pedal and steering questions... | richd | Windsor Power | 2 | 12-19-2001 10:59 AM |
| REAR END/ CLUTCH PACK QUESTIONS?? | 96SNAKE | Modular Madness | 2 | 07-09-2001 03:31 PM |
| I told you I was coming with questions!! Best clutch? | 1HOTGT | Windsor Power | 2 | 04-25-2001 11:14 AM |
| Installed Clutch..Few questions? | Mad Horse | Windsor Power | 5 | 04-17-2001 12:40 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |