Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-19-2002, 06:32 AM
|
#6 |
|
Registered Member
Join Date: Mar 2001
Posts: 46
|
Don't think so. You must be thinking about the 240/300 series of inlines, not the 144/170/200/250. They are 2 different animals.
Did the head you saw have a seperate intake? If so, it's not for this block, unless it is from an Australian 250 2V head. They were still cast, but the intake was aluminum. The only way to get those is to import one over from Oz. No 'Ford' based organization in this country will sell them, the make all their money on V8 stuff. Speciality places like Powerheads.com or Clifford may carry these. The only aluminum head for the 250 is from an Australian Crossflow 250, and that won't bolt onto the US block. Al |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Car Audio System in a 90 LX V8 stang convertible | ziggy_2k | Windsor Power | 2 | 05-21-2002 12:33 AM |
| Car Audio System in a 90 LX v8 stang | ziggy_2k | Audio, Security, & Electronics | 0 | 04-30-2002 11:48 AM |
| Stang Review by Fbody guy? Why not =) | SkarodoM | Blue Oval Lounge | 7 | 10-27-2001 02:39 PM |
| Thad's stolen Stang | joe4speed | Blue Oval Lounge | 12 | 04-06-2001 12:20 AM |
| Might sell the stang. | slowride90 | Blue Oval Lounge | 2 | 02-25-2001 07:08 PM |