Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-21-2002, 10:11 AM
|
#3 |
|
Registered Member
Join Date: Mar 2002
Location: virginia
Posts: 9
|
Ive run it with the valve cover off and it looks like it getting good oiling uptop. Its got maybe 80 thou easy miles on the motor.When I put the cam in it went kinda tight and would not rotate easily. I thought that it might of been because of bearings being new. I put the timing chain on just so I could rotate it in to position and line up the marks. Turned the cam by the crank with a breaker bar. Kinda snug, but after a turn it got easy. after it ran about a half hour I broke it back down, pulled the cam and it looks good. No bangs, or dents or chips. So I figure its not the cam.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3.55:1 rear end noise, is it normal? | Mo65 | Classic Mustangs | 16 | 08-26-2002 08:07 AM |
| Motor back together - strange noise???? | DZEE'S LX | Windsor Power | 13 | 03-15-2002 12:46 AM |
| Calling all Guru's - peculiar noise after injector swap | 93GTDIN | Windsor Power | 3 | 01-09-2002 07:51 PM |
| Rear end Noise or Tranny Noise??? | jz_mustang50 | Windsor Power | 0 | 10-02-2001 05:21 PM |
| Air Intake Whistling Noise?! | sgrn | Modular Madness | 4 | 10-25-2000 09:46 AM |