Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-22-2002, 07:26 AM
|
#6 |
|
Registered Member
Join Date: Aug 2001
Location: Georgia
Posts: 84
|
On the same subject, I have been looking for new drip rails for my brothers 66. The old ones were rotted to the point of no return so we pulled them off. Mustangs Unlimited has them listed in their catalog but they have been backordered for 6mos. I was wondering if you could buy universal drip rails with the moulding allready attached then bend them to fit the opening. I need to know where to get them at. Thanks for the help.
__________________
73 coupe, 351W, GT-40 heads, edlebrock 750, offenhauser intake, .488 lift cam, 2.5 exhaust, 2 chamber flowmasters, blah, blah, blah... |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 67 fastback drip rail molding | 84GT350-1 | Classic Mustangs | 0 | 04-30-2004 08:06 PM |
| Drip rail chrome molding install | DrPhilgood | Classic Mustangs | 2 | 03-26-2004 02:25 PM |
| Rail Rockers on 289 Small Block Heads | sleeperstang | Classic Mustangs | 16 | 05-11-2003 11:34 PM |
| ARP assembly lube and thread sealer.??? | JaxMustang50 | Windsor Power | 4 | 04-15-2003 10:18 AM |
| Drip Rail Molding | Kisner | Classic Mustangs | 5 | 05-03-2002 10:09 AM |