Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-24-2002, 05:52 AM
|
#3 |
|
Registered Member
Join Date: May 2001
Location: Harrisburg, Pennsylvania
Posts: 379
|
thanks for the reply fiveoh........thats what i was syspecting was the problem ........i put new replacment springs in the heads cause i thought they would be suffitient enough,guess not .....bummer
for the most part i don't wind her up that high ,i'm probly going to run it a little bit till i get time and more money to replace them ......do you think that running it will harm the valves or anything else
__________________
the "not so old",old guy 87 Mustang GT T-top >hanlon t-5, pro 5.0, centerforce clutch ,adj. cable/quatrant ,3.27s ,full 2 1/2 ex(off road H) adj. reg. ,e-cam ,70mm TB, cobra intake ,1.7rr ,ported/milled e7ets w/crane springs ,306 balaced/decked short block w/speed pro forged flat top pistons ...257rwhp/302rwt best et 13.7@102 (4/11 ) '80 Capri (future project,currently collecting parts for 351 moter) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| val springs in stock 97 heads , quesion ? | southernstang97 | Modular Madness | 0 | 07-16-2002 11:52 AM |
| Pro-M on stock motor? | NotchJohnson | Windsor Power | 3 | 03-23-2002 10:28 PM |
| ?'s on Crane Single Valve Springs | Dangerous Dave | Windsor Power | 2 | 12-09-2001 09:19 AM |
| What are 2001-2002 Cobras Running in the 1/4 Bone Stock? | '02 Cobra Guy | Modular Madness | 3 | 11-08-2001 01:23 AM |
| Suspension Opinions-Long | 95Convert | Windsor Power | 3 | 01-28-2001 03:07 PM |