Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
04-24-2002, 05:56 PM
|
#4 |
|
Registered Member
Join Date: Mar 2002
Location: Rockingham,N.C.
Posts: 80
|
efi dist without computer
I can't remember where I found this or even if it will work but here goes the wiring steup for using a efi dist. without a computer
starting at the bottom of the module 4 start signal (starter solenoid wire) 3 ignition switched 12 v power source 2 negative side of coil 1 ground Like I said I don't even know if it will work but its worth a try! good luck and let me know if it works!
__________________
88 Notchback orig. 4 cylinder car with a efi v8 swap from a wrecked 89 5.0 hatch,edelbrock performer rpm's 190/160,typhoon intake,comp cams 1.6 rockers,65mm tb and spacer,pa performance c4 w/ 3000 stall,3.73's auburn pro, 31 spline mosers,mac off road h-pipe,1 5/8 shorties ,and 2 1/2 pro dumps,kirban fpr,190 lph walbrp. SOON TO BE BLOWN! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|