Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-27-2002, 06:11 PM
|
#8 |
|
Registered Member
Join Date: Apr 2002
Location: Palm Bay,FL
Posts: 24
|
I'm not sure about Richmond gears. I would recomend cleaning the housing very well and replace the carrier bearings also. As for the turning torque on the pinion nut, I have a Snap-on turning torque wrench. I'm not sure about the spec right now. I can check when I go to work on Monday.The torque wrench ran about $350 bones.Good luck
__________________
Best E/T-13.2 Best MPH-108 Mods-Full exhaust,U/D pulleys,73mm mass air,70 mm M/A,Cobra intake,Crane 1.7 R/R,E303 Cam,3.55 gear,125HP Nitrous Works. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1996 Gt Auto To Auto Swap Now It Won't Run In Gear. | the69dr | Modular Madness | 1 | 10-27-2003 08:54 AM |
| Serious problem after gear swap....... | 1bad89lx | Windsor Power | 2 | 03-11-2003 01:00 AM |
| Gear swap instructions? | GodStang | Windsor Power | 2 | 08-14-2002 05:19 AM |
| Gear Swap | 96Saleen | Modular Madness | 6 | 07-20-2002 12:18 AM |
| Engine Swap & gear change | LABARINTH | Modular Madness | 1 | 03-12-2002 03:41 PM |