Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-06-2002, 07:31 PM
|
#4 |
|
Registered Member
Join Date: Sep 2000
Location: Lafayette, Indiana
Posts: 120
|
I used the stock ones in mine but I have 3.55's. It is one of those things where you need to buy a shim kit and keep trying different thicknesses until you hit the right combination. What ever you take out from one side you need to add to the other side so you can keep the preload on the bearings right. I would first try swapping the stock shims to see if you might get lucky.
__________________
89 GT convertible, Kenny Brown level 5, Edelbrock performer, AFR 165's, Comp cams XE270HR, C&L 76, 24# inj, Crane 1.7's, 70mm BBK throttle body 298.2 hp 328.2 tq Mustang dyno "Our lady of blessed acceleration don't fail me now" Elwood Blues |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ran a fast and the fur. eclp. gst (sorry kinda long) | explicitone | Stang Stories | 6 | 06-21-2002 01:43 PM |
| Tranny blues (long) | mike5p01 | Windsor Power | 2 | 06-09-2002 12:24 PM |
| 95 Cobra - Long Tube Headers question? | Skyman | Windsor Power | 1 | 02-15-2001 10:25 PM |
| Basic gauge questions. (kinda long) | chris91LX | Windsor Power | 7 | 02-15-2001 02:42 AM |
| 1 3/4 Hooker Long Tubes vs Shorties results! | 8850 | Windsor Power | 2 | 02-04-2001 12:42 AM |