Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-10-2002, 03:22 PM
|
#1 |
|
AKA "Dr. Evil"
Join Date: Feb 1999
Location: South Fork Ranch
Posts: 1,721
|
I'm guessing you'll be using slicks with this setup at the track...
All modular GTs in my experience, whether they be 96-98 or 99 on, peter out at 5500 rpm stock. Add engine and tranny work there will be a different power curve, but as far as I'm concerned, I shift at 5500 rpm... My main concerns were the same as slow 97.... Also another thing to think about was what I stated above... I guess you're planning to run slicks with this setup, as I find it hard to grab any traction at all in 1st or 2nd with 3.73s and drag radials... (with the ATI set at a lowly 8 lbs. boost)
__________________
Uncle Sam "What the hell is up with all the gauges? Calling Captain Kirk, your ride awaits... Phasers on stun...." |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| gear install price!!!??? | DemonGT | Windsor Power | 2 | 06-07-2002 05:18 PM |
| Help Quick Please! Ring gear install question??? | 90'5.0 Conv | Windsor Power | 5 | 05-03-2002 07:53 PM |
| 3.73 Gear Install | PonyPride | Modular Madness | 9 | 10-09-2001 08:45 PM |
| what is the going price of gear install? | 82 GT | Windsor Power | 9 | 03-08-2001 05:16 PM |