Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-10-2002, 07:09 PM
|
#2 |
|
Registered Member
Join Date: May 2001
Location: Valdese, NC
Posts: 361
|
You can run 6 lbs easily (hope you don't see this PKRWUD) . You just need to upgarde your injectors and fuel pump. You could probably get away without them on 6 lbs, but you want to be safe and not break anything, so better safe than sorry.
Most guys usually run 2 heat ranges colder than stock on the plugs. Can't remember the number off the top of my head. And autolite plugs will do just fine. As far as plug wires, MSD and Accel both make pretty good sets for our cars.
__________________
91 single turbo vert Last edited by 91GTturbo; 05-10-2002 at 07:25 PM.. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| adjust fuel pressure on stock motor? | GhettoPop | Windsor Power | 1 | 03-22-2004 10:32 AM |
| E-303 Cam.. New install on stock motor. Do they really Idle bad?? | 89FHPLX | Windsor Power | 23 | 01-14-2002 09:00 PM |
| TIMINNG FOR A STOCK MOTOR??? | OUTPLAYN | Windsor Power | 4 | 09-02-2001 03:53 PM |
| Nitros on a stock motor with 119k miles | stevstum | Windsor Power | 3 | 07-10-2001 12:06 AM |
| best cam for stock motor aod mustang?? | Z28EATR | Windsor Power | 8 | 07-09-2001 03:22 PM |