Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-12-2002, 02:32 AM
|
#2 |
|
Registered Member
Join Date: May 2002
Location: IL
Posts: 32
|
The difference between the two the spool has no clutches no spider gears it's solid, so it wil not slip going around corners were the the limit-slip has the clutches & the spider gears to alou slipping when turning.Think of it this way when you turn say to the right the left rear tire has to travel futher then the right rear tire with a spool they are turning at the same speed.Sorry so long good luck Tim.
__________________
1999 Mustang Cobra Solid Axle w/ 4.56's Magnaflow Cat-Back Dr.Gas O/R X-Pipe JBA 1-5/8ths Shorty Headers Homemade Powerpipe March Pulleys JMS Chip Steeda Tri-Ax Shifter Best E.T. w/ parts listed & BFG 275/40/17 D/Rs (10-26-'02; not including JMS Chip)- 12.95 @106.82, 1.79 60FT. Best MPH- 107.43 New Best MPH (4-26-03)- 109.45 316 RWHP/ 309 RWTQ |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rebuilding Posi Unit | PurduePete | Windsor Power | 2 | 07-19-2004 04:49 PM |
| posi unit and 3.73 | Rodoggx | Windsor Power | 12 | 04-30-2004 12:00 AM |
| Help with fuel sending unit install on 68 mustang | ciara | Classic Mustangs | 3 | 07-09-2003 01:55 AM |
| Auburn posi ???'s...please help | dragstang86 | Windsor Power | 6 | 10-08-2002 05:52 PM |
| New Auburn Posi, noise when turning | bark3rd | Modular Madness | 7 | 11-07-2001 05:17 PM |