Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-12-2002, 02:02 PM
|
#3 |
|
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
Sounds about right, but watch the tire wear for too much/little camber.
Also, if you can borrow someone's bumpsteer measuring tools and bumpsteer it, you might find some room for improvement there too...
__________________
Darius Rudis, Moderator Corner Carvers Delight 1989 Mustang LX - Open Track Car http://www.dariusrudis.com |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Front End Alignment | orlowted | Classic Mustangs | 5 | 03-26-2004 08:38 AM |
| got my alignment done today.... | green94droptop | Windsor Power | 1 | 08-12-2001 07:36 AM |
| Do I need to use pressure plate alignment dowels with clutch install? | TROYXTROY | Windsor Power | 4 | 01-25-2001 02:12 PM |
| Alignment Basics for Dummies | feweathers | Corner Carvers Delight | 0 | 12-15-1999 04:18 PM |
| torque settings | Wavsail | Classic Mustangs | 0 | 06-07-1999 12:42 AM |