Wiring Problem, need help

[PKRWUD]

That one is a little tricky. It goes to your ignition switch, but as follows:

There is a wire that goes from the Run terminal of the ignition switch, through a ballast resistor, and to the pos side of the coil. However, there is also a starter bypass wire that goes from the Start terminal on the ignition switch to a splice just past the ballast resistor in the first wire mentioned, and then to the pos side of the coil. To make matters more complicated, the red wire from the module also splices into this same wire, but it does so on the ignition switch side of the resistor.

I hope this helps.

Take care,
-Chris