Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-22-2002, 01:36 PM
|
#1 |
|
Resident Redneck
Join Date: Jan 2002
Location: Cecil County, MD
Posts: 165
|
fiveohpatrol is right, there are a lot of NO2 cams out there that aren't custom. Have you looked at AFM? The cam would give you a lot more power with the juice though. I say swap. Good luck though.
-Billy
__________________
95' GT: 306, XL Ross Pistons, Ultra Lite H-beam Rods, Forged Scat Crank, 28oz Romac, 28oz JW flexplate, FTI ported RPM II intake, FTI ported AFR 165's, FTI custom cam, 75mm BBK Throttle body, 80mm Pro-M, 4800 PI stall, PA Super Comp AODE, Strange 33 spline race axles, Strange ultra lite spool, Motive lite 4.30's, Strange rear race brakes, Mega bite seniors, double adjustable uppers w/spherical bushings, Racecraft anti-roll bar, LPW rear end girdle, Metco d/s loop, A9L conversion, AFM PMS |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Beware Of Crower Cams!!!!! | 82 GT | Windsor Power | 1 | 06-04-2003 10:14 PM |
| What could I gain by swapping to longtubes? | Grn92LX | Windsor Power | 2 | 05-29-2002 07:50 PM |
| how can you tell apart 99 heads and cams and 98 heads and cams | 98 NosStang | Modular Madness | 5 | 09-25-2001 11:51 PM |
| crane cams survey | BurninBurt | Modular Madness | 0 | 06-05-2001 11:47 AM |
| Question concerning HEADS and CAMS...... | QuickSilver96 | Modular Madness | 0 | 12-12-1999 02:16 AM |