Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-23-2002, 07:27 PM
|
#3 |
|
Registered Member
Join Date: Apr 2002
Location: Kingston, Ontario
Posts: 351
|
if you aren't doing too much to the car then I wouldn't bother with the conversion
the speed density can handle new heads and mild cams and most other bolt ons. you may have problems with a power adder, I'm not sure Dark 5.0 on this site still has speed density and knows a bit about them I still have speed density too and I think I'll wait till I'm pushing almost 400 hp before I do the swap ( unless I have problems ) sometimes you need to pay a little more attention to tuning but for the most part it should work for you
__________________
 '88 lx, Black on Black, check it out here Spent all my money on school, what a dumb mistake I'm old enough to know better, but still too young to care. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another mass air conversion? | chuck88 | Windsor Power | 1 | 02-22-2003 12:09 PM |
| mass air conversion?? | chuck88 | Windsor Power | 12 | 10-10-2002 12:54 PM |
| Mass Air Conversion on '92 5.8L for my F-250? | Vandal_89 | Built Ford Tough | 8 | 09-09-2002 10:21 AM |
| mass air 87GT conversion | greydan | Windsor Power | 3 | 01-02-2002 07:57 PM |
| Mass Air Conversion | z3beemer | Windsor Power | 2 | 07-04-2001 04:00 PM |