Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-23-2002, 09:01 PM
|
#2 |
|
Registered Member
Join Date: Sep 1999
Location: Grove City Ohio
Posts: 226
|
Mine are Torx screws. Is that the answer you are looking for?
__________________
91 Coupe with fresh rebuild. Running Stage 2 Avenger heads (51cc chambers), Stage 2 cam (.549, .566)1.72 Crane Gold Race rockers, Port matched GT-40 upper & lower, 75mm Bullet MAF, 65mm Accufab TB, MSD 6AL, Long Tubes through off road and 2 chamber flowbastards. Stock T-5, 3.73 gears, Center Line Convo-Pros with skinnies up front. My baby is now bottle fed!!! Best time on the motor was 12.92 at 109.57. UPDATE - Getting Ready to install: Tremec 3550, Blowproof Bellhousing, Strange Shocks/Struts, Moroso Springs, Upper/Lower control Arms, 31 spline axles and new differential. After this..... 347 heart transplant and Rollcage. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| code 1518 on the scan tool | mellow98cobra | Modular Madness | 0 | 05-15-2003 01:58 PM |
| 6pt. and 12 pt.? Tool question. | 95mustanggt | Blue Oval Lounge | 22 | 05-17-2002 01:35 PM |
| Tool or Staind? | TJR | Blue Oval Lounge | 25 | 05-19-2001 04:01 PM |
| Reading Computer Codes-what tool?? | Stang_ROTY | Windsor Power | 2 | 05-05-2001 02:48 AM |
| Front Main Removal / Installation Tool | John93GT | Windsor Power | 1 | 01-17-2001 11:39 AM |