Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-31-2002, 09:56 AM
|
#17 |
|
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
One thing no one has mentioned is that unless the factory EEC see's 180 degrees it will stay in limp mode which pulls timing and adds fuel.
The fan shroud is very important and should help solve your problems, the electric fan will be a good investment, make sure you get a decent fan controller. Like Rob said the Water Wetter is made to be used with plain water, no anti freeze. Evans makes a additive that is said to decrease temps a lot but it runs about $40/gal.
__________________
D/R 10108 NMRA Drag Radial, 25.5 chassis, F1R Check out RNH Performance Performance Engines and Custom Fabrication. From Mild to Wild we can build what you want, when you want it. FOR SALE Stainless Steel Torque Box Supports |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Water Temp sender | Faster & Mor Furious | Modular Madness | 0 | 08-12-2003 07:43 PM |
| Temp. Skyrockets After New AC Compressor | Mustangbelle306 | Windsor Power | 3 | 08-19-2002 05:06 PM |
| Car's running hot... | Sonics2042 | Windsor Power | 8 | 07-16-2002 04:50 PM |
| Elec. water temp guage ?s | blueneonman1 | Windsor Power | 4 | 05-23-2002 10:13 AM |
| Temp sensor question | RB92GT | Windsor Power | 2 | 06-23-2001 12:23 PM |