Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-31-2002, 11:13 PM
|
#17 |
|
Registered Member
Join Date: May 1999
Location: Georgia
Posts: 3,866
|
24lbers are better for your combo, and they can be run with nitrous safely, especially a wet kit.
Lower fuel pressure usually runs stronger, I had good results around 35 psi. the Kirban FPR does go down to around 22 psi or so if you wanted to try that route. 24 lbers are better for your combo., but might not be the answer to your problem. a lot of cammed stangs dont start screaming until 3000 rpm. what gear ratio do you have? |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fuel injected to Carbureted | StateTroopCoupe | Windsor Power | 1 | 01-20-2004 12:22 AM |
| injected to carbed !??? | pedley | Windsor Power | 3 | 01-19-2004 05:38 PM |
| injected motor to carburated motor | Mustego | Windsor Power | 4 | 01-05-2004 02:36 PM |
| need some advice for people that have a fuel injected stroked 351 | Mustangboy89 | Windsor Power | 0 | 09-19-2002 11:34 PM |
| Fuel injected | mean81GT | Blue Oval Lounge | 3 | 07-17-2002 09:54 PM |